MOTOREX CHAINLUBE with PTFE is a fully synthetic chain lubricant with highly dust- and dirt-repellent properties. The special formulation with PTFE reduces friction while still ensuring optimum lubrication of the chain links. The innovative composition of high-quality additives enables excellent chain penetration as well as precise and smooth gear changing. It is intended for use on racing bikes that make short trips in dry conditions only. However, mountain bikes can also benefit from the performance of CHAINLUBE with PTFE if the climate and mileage conditions are similar.
Features
- With PTFE for reduced friction
- Outstanding resistance to dirt and dust
- Dry and colourless, non-sticky wax film
- Enables precise and smooth gear changing
- Especially for short trips in dry conditions
- Also perfect for racing
Application
- Start by shaking MOTOREX CHAINLUBE with PTFE well. Then apply to the dry chain both inside and out. Leave it to take effect for a short while, then remove excess CHAIN OIL with a cloth. Application temperature optimal above 10°C. The dirty chain can easily be cleaned with MOTOREX BIKE CHAIN DEGREASER.
Dosage
- As the saying goes: as little as possible, as much as necessary. Apply a thin layer of CHAINLUBE with PTFE to the entire length of the chain both inside and out and leave it to take effect for a few minutes. Then remove the excess oil with the cloth. The drive should not be used for several hours so that the lubricant can take effect and dry out as best as possible. Ideally, leave the chain oil to take effect overnight. If the chain still has a bit of an oily sheen after being left to take effect for a long time, wipe the chain down again with the cloth.
Suositellut lisävarusteet
Vesiurheilu
Urheilu
fi
