Fender Engine Room LVL5 Virtalähteen adapteri

Isolated Power Supply for Pedals — Clean 9V DC for Smaller Boards

The Fender Engine Room LVL5 Power Supply delivers clean, isolated 9V DC power to effects pedals through five dedicated outputs. Each output is rated at 500mA, so high-current digital pedals run at full specification without sharing ground paths. This unit works standalone for smaller pedalboards or daisy-chains with the LVL12 for larger rigs.

What Sets the Engine Room LVL5 Apart

Most competing supplies at this tier reserve high current for one or two outputs — this unit delivers 500mA on every channel. A 2-color LED indicator on each output confirms power flow and current consumption at a glance. The low-profile anodized aluminum chassis fits beneath most pedalboards.

Power Output — Five Isolated 9V Channels

Each channel runs on its own isolated rail, eliminating hum and ground loops between pedals.

• Outputs: 5 ground-isolated 9V DC channels — eliminates hum and ground loops between pedals
• Per-Output Current: 500 mA — runs power-hungry digital pedals like UAFX units
• The total power capacity reaches 22.5 W, which provides plenty of headroom for five simultaneous 500mA devices.
\n

Chassis and Mains — Built for the Road

Crafted from anodized aluminum, the chassis resists scratches and stays cool under load. A universal mains input works on any voltage from 100-240Vac at 50/60Hz, so the same unit plays European, North American and Asian stages without a converter.

• Material: Anodized aluminum — road-ready at minimal weight
• Dimensions: 85 mm W × 42 mm H × 131.3 mm D — low-profile fit under most pedalboards
• The unit weighs exactly 375 g.
• Mains Input: 100-240Vac, 50/60 Hz via IEC connector with 2 m IEC cable — global compatibility
\n

Included Cable Kit — Ready for Any Pedal

Fender ships the LVL5 with a cable kit that covers the most common pedal power connectors, so most rigs need no extra adapters.

• 2.1mm Barrel Cables: 2 × 60 cm, 4 × 45 cm, 1 × 30 cm — covers short and medium pedalboard runs
• Included adapter cables consist of 2.5mm to 2.1mm (standard/reverse polarity), 3.5mm TS to 2.1mm, and 9V battery clips to 2.1mm for legacy hardware support.
\n